Club Car Carryall 295 Maintenance And Service Manual page 195

TROUBLESHOOTING AND ELECTRICAL SYSTEM:
DIESEL VEHICLES
2106
Figure 12-8 Frame Ground
TEST PROCEDURE 4 – Key Switch (Starter Circuit)
See General Warnings, Section 1, Page 1-2.
1. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2. Remove the key switch. See Key Switch Removal on page 14-7.
3. Ensure that the key switch connector is connected correctly and is tight. If it is not, repair or replace as necessary.
4. Set the multimeter to 200 ohms.
5. Check the B and A key switch terminals.
5.1. Use alligator clips to connect the multimeter probes between the B and A terminals. With the key switch
in the START position, the multimeter should indicate continuity (Figure 12-10, Page 12-15). If the
multimeter does not indicate continuity, the key switch has failed and should be replaced. See Key Switch
Removal on page 14-7.
5.2. If the multimeter indicates continuity between the B and A terminals with the key in any position other than
START, the key switch has failed and should be replaced. See Key Switch Removal on page 14-7.
REAR VIEW
B
S
A
I
B
A
Continuity Diagram
I
Key Position
PRE-
HEAT
2108
Figure 12-10 Key Switch Terminals and Continuity
6. Check the B and I terminals.
FRONT VIEW
B B
S S S
A A A
I I
O I
OFF ON
START
Diagram
2013 Carryall 295/XRT 1550 Maintenance and Service Manual
2107
Figure 12-9 Engine Ground (Under Starter)
B
S
I
12
Test Procedures
Page 12-15