Rear Wheel Bearing Installation - Club Car Carryall 295 Maintenance And Service Manual

DRIVETRAIN COMPONENTS
2215
Figure 17-20 Rear Wheel Bearing

REAR WHEEL BEARING INSTALLATION

1. Clean inside axle tube (1) where new bearing will sit and lightly lubricate the bore with anti-seize compound
(Figure 17-20, Page 17-17).
2. Using an appropriate sized bearing driver that fits the outer race, drive in new bearing (3) until fully seated.
3. Install retaining ring (2).
4. Clean axle shaft and carefully install axle tube (1) to avoid damaging new seals. See Rear Axle Tube and
Axle Shaft Installation on page 17-16.
1
2013 Carryall 295/XRT 1550 Maintenance and Service Manual
Rear Axle Tubes, Axle Shafts and Wheel Bearings
17
Page 17-17