Club Car Carryall 295 Maintenance And Service Manual page 175

TROUBLESHOOTING AND ELECTRICAL SYSTEM:
GASOLINE VEHICLES
7. The orange wire should remain disconnected for this step. Place the black probe of the multimeter on the (1)
terminal of the fuel gauge/hour meter and place the red (+) probe on the (4) terminal of the fuel gauge/hour
meter (Figure 11-29, Page 11-33). The voltage reading should be approximately 4.94 volts. If the reading is
incorrect, replace the fuel gauge/hour meter.
WAVETEK 5XL
V V
OFF
1000 500
200 200
20 200 2
2 2m
200
20
m
m
200
2000
k m
200k
20k 200
A
2k
! !
V COM 200nA
MAX
1000 ---
FUSED
750V
1
1. 20 VDC Setting 2. Orange 3. Black 4. White 5. Blue
481
Figure 11-28 Fuel Gauge Voltage Test - Terminal 2
TEST PROCEDURE 32 – Hour Meter
See General Warnings, Section 1, Page 1-2.
NOTE: Keep the battery connected during this test procedure.
1. Place the Forward/Reverse handle in NEUTRAL. Chock the wheels.
2. With the key switch OFF, check the hour meter display. It is powered by an internal battery and should always be
on, even with the engine off and the key removed.
3. Start the engine and let it idle. See following DANGER.
DANGER
• Do not operate vehicle in an enclosed area without proper ventilation. The engine produces carbon
monoxide, which is an odorless, deadly poison.
4. With engine idling, the "hour glass" icon should flash. If not, check the low oil warning light and the oil pressure
switch. See following NOTE. See alsoTest Procedure 28 – Low Oil Warning Light Circuit on page 11-30.
NOTE: The hour meter is designed to record actual engine running time and will not start adding increments until the
engine is running and the oil pressure switch has opened.
5. If the hour meter still does not function after the low oil warning light, oil pressure switch, and all of the appropriate
wires have been checked for continuity, replace the fuel gauge/hour meter.
TEST PROCEDURE 33 – Light Switch
See General Warnings, Section 1, Page 1-2.
NOTE: The headlight circuit is protected by the 20-amp fuse. Check the fuse before this procedure is performed. See
Test Procedure 2 – Fuse on page 11-11.
1. Disable the vehicle. See Disabling the Vehicle on page 1-3.
2. Remove the light switch from the instrument panel. See Light Switch Removal on page 13-11.
5
4
3
2013 Carryall 295/XRT 1550 Maintenance and Service Manual
WAVETEK 5XL
V OFF V
1000 500
200
200
20
200
2 2m
200 20
m
m
200
2000
m
k
200k 2
20k 200
2k A
! !
V COM 200nA
MAX
1000 ---
FUSED
750V
1
1. 20 VDC Setting 2. Orange
482
Figure 11-29 Fuel Gauge Voltage Test - Terminal 4
11
Test Procedures
Page 11-33