Club Car Carryall 295 Maintenance And Service Manual page 162
Hide thumbs
Also See for Carryall 295:
- Maintenance and service manual (456 pages) ,
- Owner's manual (72 pages) ,
- Owner's manual (84 pages)
Table of Contents
Advertisement
11
Test Procedures
8.
If the readings obtained in the previous steps are incorrect, replace the diode. See Wire Harness Diode
Removal on page 13-18.
TEST PROCEDURE 11 – Diode 2 on wire 40 and 41
See General Warnings, Section 1, Page 1-2.
1.
Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2.
Remove the start relay from the multi-pin connector located on the electrical component mounting plate.
3.
Disconnect the bullet connector in the carburetor solenoid green wire (Figure 11-15, Page 11-20).
4.
Set the multimeter to the diode test function.
5.
Connect the black (–) probe of the multimeter to the 18-gauge light-green wire (w110) at the start relay multi-pin
connector.
6.
Connect the red (+) probe of the multimeter to the female side of the carburetor solenoid bullet connector.
7.
The reading should indicate an over limit (no continuity). If the diode conducts current (shows continuity) with
the meter probes connected as described, the diode has failed and must be replaced. See Wire Harness
Diode Removal on page 13-18.
8.
Reverse the multimeter probes and note the reading. The multimeter should indicate approximately 540 mV,
however, a range of 400 to 700 mV is acceptable.
9.
If the readings obtained in the previous steps are incorrect, replace the diode. See Wire Harness Diode
Removal on page 13-18.
2089
Figure 11-15 Carburetor Solenoid Bullet Connector
TEST PROCEDURE 12 – Diode 3 on wire 45 and 39
See General Warnings, Section 1, Page 1-2.
1.
Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2.
Raise the hood and disconnect the multi-pin connector from the key switch.
3.
Disconnect the bullet connector in the carburetor solenoid green wire (Figure 11-15, Page 11-20).
4.
Disconnect the 18-gauge purple wire (w42) from the oil light.
5.
Disconnect the 18-gauge blue wire (w25) from the fuel gauge/hour meter.
Page 11-20
2013 Carryall 295/XRT 1550 Maintenance and Service Manual
TROUBLESHOOTING AND ELECTRICAL
SYSTEM: GASOLINE VEHICLES
Advertisement
Table of Contents
Troubleshooting
