15
Clutches
Driven Clutch Removal
1.
Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2.
Remove the top air filter hose from the filter canister.
3.
Remove the clutch outer cover. See Clutch Outer Cover Removal on page 15-36.
4.
Remove the drive belt as instructed. See Drive Belt Removal on page 15-29.
5.
Remove the bolt and washer from the center of the clutch and discard bolt.
6.
Remove the driven clutch. See following CAUTION.
CAUTION
• Do not hit or tap the clutch with a hammer. Do not pry the clutch. These actions will damage the clutch.
Driven Clutch Disassembly
The following service tools are required to disassemble and assemble the driven clutch. They are available from
a service parts representative:
• Spring compression base (CC P/N 102603501)
• Spring compression collar (CC P/N 102605201)
• Spring compression nut (CC P/N 102606101)
3
2174
Figure 15-29 Driven Clutch Service Tools
1.
Place the driven clutch onto the Spring compression base (CC P/N 102603501) (1) (Figure 15-29, Page
15-34).
2.
Place the Spring compression collar (CC P/N 102605201) (2) onto the driven clutch.
Page 15-34
2013 Carryall 295/XRT 1550 Maintenance and Service Manual
2
1
GASOLINE ENGINE, MUFFLER, FUEL
SYSTEM, AND CLUTCHES