Club Car Carryall 295 Maintenance And Service Manual page 173
Hide thumbs
Also See for Carryall 295:
- Maintenance and service manual (456 pages) ,
- Owner's manual (72 pages) ,
- Owner's manual (84 pages)
Table of Contents
Advertisement
TROUBLESHOOTING AND ELECTRICAL SYSTEM:
GASOLINE VEHICLES
TEST PROCEDURE 29 – 12-Volt Accessory Receptacle
See General Warnings, Section 1, Page 1-2.
NOTE: Keep the battery connected during this test procedure.
1.
Disable the vehicle. See Disabling the Vehicle on page 1-3.
2.
Set the multimeter to 20 VDC.
3.
Measure the voltage between the center contact and the outer contact of the accessory receptacle. The voltage
should be approximately 12 VDC.
4.
If the voltage is not approximately 12 VDC, check the 10-amp fuse on the orange/white wire (w115) located on the
electrical component mounting plate. See Test Procedure 2 – Fuse on page 11-11.
5.
If the fuse is good, check the continuity of the wires connected to the accessory receptacle.
6.
If the wire continuity is good, replace the accessory receptacle.
TEST PROCEDURE 30 – Fuel Level Sending Unit
See General Warnings, Section 1, Page 1-2.
WARNING
• To avoid the possibility of fire or explosion, make sure the fuel tank cap is securely in place while
performing this test procedure.
1.
Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2.
Disconnect the orange wire from the center post of the fuel level sending unit.
3.
With a multimeter set to 2k ohms, place the red (+) probe on the center post of the sending unit. Place the black
(–) probe on the ground connection of the sending unit (Figure 11-26, Page 11-31).
2100
Figure 11-26 Fuel Level Sending Unit Test
4.
The following resistance readings (in ohms) should be indicated, depending on the position of the float inside
the fuel tank. The resistance reading will vary according to the exact position of the float. The following table
may be used as a guideline to determine if the fuel level sending unit is operating correctly. Make sure the float
is at the surface of the fuel in the tank.
TABLE CONTINUED ON NEXT PAGE
2013 Carryall 295/XRT 1550 Maintenance and Service Manual
11
Test Procedures
Page 11-31
Advertisement
Table of Contents
Troubleshooting
