Front Differential Installation - Club Car Carryall 295 Maintenance And Service Manual

DRIVETRAIN COMPONENTS
2197
Figure 17-7 Roll Pin in Driveshaft and Pinion Shaft
9. Disconnect the electric clutch harness from the differential at the connector behind the splash guard (Figure
17-9, Page 17-5). See following NOTE.
NOTE: It may be necessary to open one or two splash guard fasteners to access the connector.
10. Remove the four flange-head bolts from the frame support weldments (Figure 17-10, Page 17-5). See following
NOTE.
NOTE: Do not remove the flange-head bolts from the differential plate and differential housing.
11. Pull the front differential and differential plate forward and out of the driveshaft. Tip the unit downward and
remove it from the vehicle. See following NOTE.
NOTE: It is not necessary to remove the differential from its mounting plate to repair or service the unit.
2199
Figure 17-9 Differential Clutch Connector

FRONT DIFFERENTIAL INSTALLATION

See General Warnings, Section 1, Page 1-2.
2198
2200
2013 Carryall 295/XRT 1550 Maintenance and Service Manual
Figure 17-8 Differential Vent Tube
Figure 17-10 Front Differential Plate Bolts
17
Front Differential
Page 17-5