Robot Installation (Thl300 And Thl400); Installation Environment - Toshiba THL Series Instruction Manual

7.

Robot Installation (THL300 and THL400)

7.1

Installation Environment

Table 7.1 shows the environmental conditions for the location in which the robot and
controller are to be installed.
Table 7.1 Environmental conditions for robot and controller
Item
Temperature
Humidity
Altitude
Vibration
Dust
Gas
Degrees of protection
Overvoltage category
Protection against
electric shock
Pollution Degree
Sunlight
Power noise
Magnetic field
Other ambient
environment
• Do not place the robot or controller near combustible.
Doing so could lead to fires if it ignites due to a fault, etc.
TRANSPORTATION AND INSTALLATION MANUAL
In operation: 0 to 40°C
In storage: –10 to 50°C
20 to 80% (Non-condensing)
DO NOT install the robot where it may be subject to fluids such as water.
1000 m or less
2
In operation: 0.98 m/s or less
No inductive dust should exist.
Consult with Toshiba Machine first if you wish to use the robot and controller in a dusty
environment.
No corrosive or combustible gas should exist.
IEC60529 IP10(robot only) IP20(controller only)
IEC60664-1 ClassⅢ(controller only)
IEC61140 ClassⅠ(controller only)
IEC60664-1 Pollution Degree 3(controller only)
The robot and controller should not be exposed to direct sunlight.
A heavy noise source should not exist nearby.
A heavy magnetic field source should not exist nearby.
Must be free from iron powder, oil, salt, and organic solvents. Must not be exposed to
water.
!
Specifications
DANGER
66
STE 85356