Toshiba THL Series Instruction Manual page 130

b) When the controller is mounted on the rack, the weight of the controller should be
supported with the legs of the controller. Screw holes for rack-mounting the
controller are used for securing the controller panel, and the weight of the controller
cannot be supported only with these screws.
c) On the front of the controller, a clearance of approx. 90 mm should be provided for
connecting the connector of the teach pendant. Even if the teach pendant is not
used, a clearance of approx. 60 mm is required for connecting a dummy plug.
Fig. 12.5 Clearance of controller front side (TS3000 and TS3000E)
TRANSPORTATION AND INSTALLATION MANUAL
90 mm or more
Teach pendant
130
60 mm or more
Dummy plug
STE 85356