Micro vibration may occur depending on the robot posture. If micro vibration occurs, reduce
the acceleration speed to use the robot.
Put the Z-axis (axis 3) in the raised position as much as possible, when moving Axes 1, 2,
and 4.
Moving Axis 1, 2, or 4 when the Z-axis is in low positions can lead to premature damage to
the ball screw spline (Z-axis shaft).
If Axis 1, 2, or 4 must be moved while the Z-axis is in low positions due to unavoidable
circumstances, prevent the ball screw spline vibrations by using the SPEED,
ACCEL/DECEL, and PAYLOAD commands to adjust the operation speed and
acceleration.
If Axis 1, 2, or 4 is moved while the Z-axis is in low positions, be extremely careful not to
collide with any objects. Even if Axis 1, 2, or 4 is moved at low speed, a collision or other
impact with an object can damage the ball screw spline (Z-axis shaft) before alarm occurs.
TRANSPORTATION AND INSTALLATION MANUAL
!
CAUTION
33
STE 85356