Table of Contents
Advertisement
Chapter 5: Installing the Switch in an Equipment Rack
Removing the Bumper Feet
The bumper feet included with the switch should not be used when
installing the device in an equipment rack. If they are already installed,
perform the following procedure to remove them:
1. Place the switch upside down on a level, secure surface.
2. Use a small flat-head screwdriver to gently pry the feet from the
bottom of the switch. Refer to Figure 46.
Figure 46. Removing the Bumper Feet
3. Turn the switch back over.
4. Go to"Installing the Switch" on page 89.
88
Advertisement
Table of Contents
