Table of Contents
Advertisement
Chapter 2: Beginning the Installation
64
5. Visually inspect the product for damage.
6. Visually inspect the front panel for the components shown in Figure 1
on page 16.
7. Verify that there are two pre-installed fan modules in FAN A and FAN
B slots on the rear panel. Refer to Figure 2 on page 17 and "AT-
FAN05 Cooling Fan" on page 48.
Note
Do not power on the switch if it is missing a fan module.
8. Go to "Verifying the Accessory Kit" on page 65.
Advertisement
Table of Contents
