Leds; Figure 3: Link And Activity Leds For Ports 1 To 24; Table 1: Link And Activity Status Leds For Ports 1 To 24 - Allied Telesis 950 Series Installation Manual

LEDs

The LEDs are located between the ports. Each port has one LED. Refer to
Figure 3.
Top Transceiver Port LED
The LEDs displays link and activity status. The possible LED states are
described in Table 1 on page 21.
Table 1. Link and Activity Status LEDs for Ports 1 to 24
Solid Green
Flashing Green
Solid Amber
Flashing Amber
Off
Figure 3. Link and Activity LEDs for Ports 1 to 24
State
The transceiver has established a 10Gbps
link to a network device.
The transceiver is transmitting or receiving
data in 10Gbps.
The transceiver has established a 1Gbps
link to a network device.
The transceiver is transmitting or receiving
data in 1Gbps.
Possible causes of this state are listed
here:
- The transceiver slot is empty.
- The transceiver has not established a
link to a network device.
- The LEDs are turned off. To turn on the
LEDs, use the eco-friendly button.
x950 Series Installation Guide for Stand-alone Switches
Bottom Transceiver Port LED
Description
21