Table of Contents
Advertisement
Chapter 7: Verifying and Configuring the Switch
118
10. Enter the WRITE command to save your change in the configuration
file. The switch displays the confirmation prompt in Figure 67.
awplus# write
Building configuration ...
[OK]
awplus#
Figure 67. Saving the Changes with the WRITE Command
If this is the first management session, the switch automatically
creates the Default.cfg file in flash memory to store your changes.
11. Enter the REBOOT command to reboot the switch.
12. At the confirmation prompt, type "Y" for yes.
13. Wait two minutes for the switch to initialize its management software
and then examine the Switch ID LED again. The switch is ready for
normal network operations as a stand-alone unit if its ID number is "0."
If the number is "1 or higher," repeat this procedure, being sure to save
the configuration change with the WRITE command in step 11.
14. Go to "Configuring Ports 25 to 37" on page 119.
Advertisement
Table of Contents
