Figure 81: Placing The Ethernet Line Card In Its Anti-Static Bag; Figure 82: Installing The Line Card Blank Cover - Allied Telesis 950 Series Installation Manual

Figure 81. Placing the Ethernet Line Card in its Anti-static Bag
8. Do one of the following:
 For instructions on how to install another card in the slot, start with
step 2 in "Installing an Optional XEM2 Ethernet Line Card" on
page 76.

If you are not installing another line card in the slot now, continue
with the next step to install the blank cover.
9. Orient the blank cover as shown in Figure 82, with the notch on the
bottom left, and slid it into the slot.
Notch
Figure 82. Installing the Line Card Blank Cover
10. Tighten the two screws to secure it to the switch. Refer to Figure 83 on
page 140.
x950 Series Installation Guide for Stand-alone Switches
139