Table of Contents
Advertisement
The sides of the switch have two sets of holes. One set is for installing
the switch on a wall with the brackets and the other is for the AT-
RKMT-SL01 Rack Mounting Kit. For this procedure, you need to use
the bracket holes, identified in Figure 44 on page 86.
3. After attaching the brackets to the side of the switch, have two people
hold the switch on the plywood base on the wall while you secure it
with the four provided screws. Refer to Figure 55 on page 104.
Please follow these guidelines as you position the switch on the wall:
Position the switch so that the front panel is either on the left or the
right. Refer to Figure 49 on page 94. You may not install the switch
with the front panel facing up or down.
Leave sufficient space from other devices or walls so that you can
access the front and back panels. Refer to "Recommended
Minimum Wall Area Dimensions" on page 95.
x950 Series Installation Guide for Stand-alone Switches
103
Advertisement
Table of Contents
