Configuration Switch - Agilent Technologies Infinity II 1290 User Manual

11
LAN Configuration

Configuration Switch

Configuration Switch

The configuration switch can be accessed at the rear of the module.
Figure 25
The module is shipped with all switches set to OFF, as shown above.
To perform any LAN configuration, SW1 and SW2 must be set to OFF.
N O T E
Table 10
Initialization ('Init') Mode
Link Configuration
192
Location of Configuration Switch
Factory Default Settings
Bootp, all switches down. For details see
Selection"
speed and duplex mode determined by auto-negotiation, for
details see
on page 193
"Link Configuration Selection"
Agilent 1290 Infinity II Flexible Pump User Manual
"Initialization Mode
on page 200