Setup (Dhcp) - Agilent Technologies Infinity II 1290 User Manual

11
LAN Configuration
Dynamic Host Configuration Protocol (DHCP)

Setup (DHCP)

Software required The modules in the stack must have at least firmware from set A.06.34 and the above mentioned
modules B.06.40 or above (must from the same firmware set).
1 Note the MAC address of the LAN interface (provided with G1369C
2 Set the Configuration Switch to DHCP either on the G1369C LAN
Table 13
SW 4
ON
198
LAN Interface Card or Main Board). This MAC address is on a label on
the card or at the rear of the main board, e.g. 0030d3177321.
On the Instant Pilot the MAC address can be found under Details in the
LAN section.
Figure 31 LAN Setting on Instant Pilot
Interface Card or the main board of above mentioned modules.
G1369C LAN Interface Card (configuration switch on the card)
SW 5 SW 6
OFF OFF
SW 7 SW 8 Initialization Mode
OFF OFF DHCP
Agilent 1290 Infinity II Flexible Pump User Manual