Agilent Technologies Infinity II 1290 User Manual page 195

Using Stored
When initialization mode Using Stored is selected, the parameters are taken
from the non- volatile memory of the module. The TCP/IP connection will
be established using these parameters. The parameters were configured
previously by one of the described methods.
Figure 28
Using Default
When Using Default is selected, the factory default parameters are taken
instead. These parameters enable a TCP/IP connection to the LAN
interface without further configuration, see
Figure 29
Using the default address in your local area network may result in network problems. Take
N O T E
care and change it to a valid address immediately.
Table 12
IP address:
Subnet Mask:
Default Gateway
Agilent 1290 Infinity II Flexible Pump User Manual
Using Stored (Principle)
Using Default (Principle)
Using Default Parameters
192.168.254.11
255.255.255.0
not specified
LAN Configuration
Initialization Mode Selection
Table 12 on page 195.
11
195