Agilent Technologies Infinity II 1290 User Manual page 199

Table 14
SW 6
ON
3 Turn on the module that hosts the LAN interface.
4 Configure your Control Software (e.g. Agilent ChemStation, Lab Advisor,
Agilent 1290 Infinity II Flexible Pump User Manual
LC Modules inclusive 1120/1220 (configuration switch at rear of the instru-
ment)
SW 7 SW 8
OFF OFF
Firmware Update Tool) and use MAC address as host name, e.g.
0030d3177321.
The LC system should become visible in the control software (see Note
in section "General Information (DHCP)"
Dynamic Host Configuration Protocol (DHCP)
Initialization Mode
DHCP
on page 197).
11
LAN Configuration
199