Setting The 6-Bit Configuration Switch - Agilent Technologies InfinityLab LC Series User Manual

10 Hardware Information

Setting the 6-bit Configuration Switch

Setting the 6-bit Configuration Switch

The 6-bit configuration switch is located at the rear of the module with FUSION
electronics. Switch settings provide configuration parameters for LAN and
instrument specific initialization procedures.
All modules with FUSION electronics:
•
•
•
Configuration switch
Figure 16
Preparative Binary Pumps User Manual
Default is ALL switches DOWN (best settings).
• Default IP address for LAN 192.168.254.11
For specific LAN modes switches 4-5 must be set as required.
For boot resident/cold start modes switches 1+2 or 6 must be UP.
Location of Configuration switch (example shows a G7114A/B VWD)
158