Initialization Mode Selection
The following initialization (init) modes are selectable:
Table 11
Initialization Mode Switches
1
Requires firmware B.06.40 or above. Modules without LAN on board, see G1369C LAN Interface Card
Bootp
When the initialization mode Bootp is selected, the module tries to
download the parameters from a Bootp Server. The parameters obtained
become the active parameters immediately. They are not stored to the
non- volatile memory of the module. Therefore, the parameters are lost
with the next power cycle of the module.
Figure 26
Agilent 1290 Infinity II Flexible Pump User Manual
SW 6
SW 7
OFF
OFF
OFF
OFF
OFF
ON
OFF
ON
ON
OFF
Bootp (Principle)
Initialization Mode Selection
SW 8
Init Mode
OFF
Bootp
ON
Bootp & Store
OFF
Using Stored
ON
Using Default
OFF
1
DHCP
11
LAN Configuration
193