Ip Communication Parameter Settings; Downloadable Files - Simplex 4007ES Programmer's Manual

IP File Transfer, Continued
IP Communication
Click on the Settings button near the top of the IP File Transfer Window to access the Settings
Window. The settings window shows you the IP address the program is currently using, you to
Parameter
change it if necessary.
Settings
Click on OK to confirm your selection or Cancel to erase any modification you made.
Downloadable The following types of files can be downloaded to the ES Panel FACP through its file transfer
utility.
Files
Figure 10-5. File Transfer Settings Window
• CFIG File. This is the built job file, consisting of all programming definitions in a
binary format, that the panel's CPU can execute.
• Slave Exec. Module-specific slave Exec files execute on intelligent slave modules
(listed below) and define the way in which the slave module operates. Occasionally,
changes to the functionality of a slave module may require you to download a new
slave Exec file. (For example, a change to the IDNet Slave Exec file may be necessary
to provide support for new, additional device types.) The following 4007ES modules
are "intelligent" slave devices that use a module-specific Slave Exec file.
- 25 Volt Regulator
- Zone/Relay Card
- SCU/RCU
- SDACT
• CFIG Text File. A panel with a missing or corrupt CFIG file can be restored to proper
operation by downloading a CFIG text file to the panel. The CFIG text file is
automatically built and placed in the same job directory as the "executable" CFIG file
(file ending in .CFG extension).
• Panel Exec (Master). The Panel Exec file is the "operating system" that runs on the
panel's CPU module. It manages interactions between system components.
Occasionally, changes to the functionality of the operating system may require that a
new Panel Exec file be downloaded.
10-5
4007ES Panel Programmer Manual (579-1167)
- IDNet+ Expansion Card
- CPU Bootloader Files.
- LED Module
- Remote UI