Simplex 4007ES Programmer's Manual page 81

Viewing, Adding, and Editing Lists, Continued
WalkTest
Moving Points between Groups
The WalkTest list consists of eight groups. The purpose of these groups is to allow a technician
to conduct a WalkTest in a specific area of a building (or different buildings), and limit the
activation of the building signals to only the intended area.
WalkTest Group 0 initially contains all of the monitor points and all of the signal points wired
to the panel. Each WalkTest group consists of two lines: one for monitor zones and one for
signal/relays.
Follow these steps to move points from WalkTest Group 0 (where they are initially placed) into
other WalkTest groups. Signal/relay points can exist in multiple groups, but monitor points can
be in only one group at a time.
1. Open the List Window by selecting the List Tab at the top of the Programmer.
2. Click on the WalkTest tab at the bottom of the List Window. A screen similar to the one
shown in Figure 8-4 appears.
3. Right click on WalkTest Group 0 and select Properties. A properties dialog appears. Click on
the WalkTest tab in the dialog. Remove the checkmarks from the Monitor and Control
checkboxes. Click the Apply button, followed by the OK button to close the dialog.
4. Select the monitor points to move as follows:
a.
b.
c.
5. Select the signal/relay points to move as follows:
a.
b.
c.
d.
Figure 8-4. WalkTest Tab
Right click on the WalkTest group into which you want to move the points (for exam-
ple, using Figure 8-4, right click on the line called LST WALKTEST GROUPX).
When the list of options appears, select Tag List.
In the Tag List, use the mouse or arrow keys to highlight each monitor point you want
to move into the group. Press the space bar to tag or un-tag points to be added or
deleted. A point is selected when a ">>" symbol appears to the left of the point.
Repeat these steps to move other monitor points into the group. When you move
points, the points are automatically unselected in WalkTest Group 0 - Monitor Points
and moved into the group you chose.
Right click on the WalkTest group into which you want to move the signal/relay points
(for example, using Figure 8-4, right click on the line called LST WALKTEST
GROUPX - SIGNALS/RELAYS). When the list of options appears, select Tag List.
In the Tag List, use the mouse or arrow keys to highlight each signal/relay point you
want to move into the group. Press the spacebar to tag or un-tag points to be added or
deleted. A point is selected when a ">>" symbol appears to the left of the point.
Repeat these steps to move other signal/relay points into the group.
The points that you selected in Step b above are not automatically deleted from
WalkTest Group 0 - Signals/Relays list. If you do not want these points to be in both
groups, you need to open up the WalkTest Group 0 - Signals/Relays list and delete the
points. To do this, right click on WalkTest Group 0 - Signals/Relays list. Select Tag
List. When the list of points appears, use the mouse or arrow keys to highlight each
point you want to unselect from WalkTest Group 0. Press the spacebar to deselect the
highlighted point. Points do not have the ">>" symbol to their left when they are
unselected.
8-7
4007ES Panel Programmer Manual (579-1167)