Custom Control, Continued
Step 5. Specifying
Each button accesses a tag list, with this you can select (tag) the specific points to associate
with the hazard. Follow these steps to tag points:
Hazard Area
Points
1. Click on the button corresponding to the type of suppression points you want to select. The
TagList screen shown in Figure 9-35 appears.
2. The TagList screen displays all points with the relevant suppression release point type. To
select a specific point for inclusion in the hazard area being programmed, click on the point
to highlight it and then press the space bar.
3. Click OK when you are finished selecting points. The screen containing the Tag List buttons
(Figure 9-34) reappears. Click Next when all points associated with this hazard area have
been chosen.
4007ES Panel Programmer Manual (579-1167)
Figure 9-35. Tagging Points
9-32
Continued on next page