Editing Standard Component Properties, Continued
Editing the NAC
To edit the NACs tab (Figure 6-15):
Power Supply
1. Select a circuit to configure in the table.
2. Select a point type from the Point Type drop-down list.
3. Enter a custom label.This label should make the point easily identifiable.
4. Select the EOL resistance from the EOL Resistance drop-down list.
5. Click Apply > OK to confirm the edits.
To edit the AuxNAC tab (Figure 6-16):
1. Select a circuit to configure in the table.
2. Select a point type from the Point Type drop-down list.
3. Enter a custom label. This label should make the point easily identifiable.
4. Click Apply > OK to confirm the edits.
4007ES Panel Programmer Manual (579-1167)
Figure 6-15. NAC - NACs Tab
Figure 6-16. NAC - AuxNAC Tab
6-10