Cabletron Systems SmartSwitch 2500 Reference Manual page 46

ATMRoute
Output Parameter
[Metrics Tag]
[Ptse Id]
[Advertising]
[Oper Status]
Descriptions
Operator Parameters/Permissions
[PortNumber] <portnumber>
add atmroute
[ATMAddr] <atmaddress>
[PrefixLength] <prefixlength>
[AddressIndex] <addressindex>
[Type] <type>
[Scope] <scope>
[MetricsTag] <metricstag>
Administrator
[PortNumber] <portnumber>
delete
[ATMAddr] <atmaddress>
atmroute
[PrefixLength] <prefixlength>
[AddressIndex] <index>
Administrator
All
show atmroute
Examples
switch_prompt # show atmroute
Num(ALL)
Num Port Number ATM Address
================================================================================
1 CPU 39:00:00:00:00:00:00:00:00:00:a3:87:0b:00:00:1d:a3:87:0b I MGMT
2 CPU 39:00:00:00:00:00:00:00:00:00:a3:87:0b:00:00:64:01:01:16 I MGMT
3 -- 39:00:00:00:00:00:00:00:00:00:a3:87:0b:00:20:d4:28:c1:ff I MGMT
4 CPU 47:00:79:00:00:00:00:00:00:00:00:00:00:00:a0:3e:00:00:01 I MGMT
2-18 SmartSwitch ATM Switch Reference Manual
Description
Index into the listing of traffic parameter values that apply for connectivity between the
switch and the reachable address prefix.
For reachable addresses learned through PNNI, this parameter contains the value of the
PTSE identifier for the PTSE that is originated by the originating node and contains the
information group(s) describing the reachable address. For reachable addresses learned
by means other than PNNI, this parameter is set to zero.
Whether or not the local switch advertises the local address into the PNNI domain.
Possible values are: Yes and No.
Whether or not the reachable address prefix is operationally valid and whether it is
advertised by this node. Possible values are: Advertised, Active, and Inactive.
:
Description
Adds a route to a reachable address from the switch.
Deletes a route to a reachable address from the switch.
Displays the configured routes from the switch.
Console Commands
Type Proto