Ipatmclient - Cabletron Systems SmartSwitch 2500 Reference Manual

Console Commands

IPATMClient

Use IPATMClient to add or modify IP/ATM clients on the switch. Any of the clients can act as an ARP server.
Use the Client attribute to delete, restart, or show IP/ATM clients.
Note
Operators
add, modify
Parameters
This attribute has no output parameters.
Input Parameter Description
[ClientNumber] Number of the client.
[ServerType] IP/ATM server type. Possible values are: Local,
External, or None. Local means the client is an
ARP server for a VLAN on this switch. External
means the client is an ARP server for another
switch.
[ServerAddress] ATM address of the IP/ATM server. If ServerType
is None or Local, then enter the default (Local
means the client also acts as an IP/ATM server for
that VLAN). If ServerType is External, enter the
ATM address of the external server.
[IPAddress] IP address of the client.
[NetMask] IP netmask of the client. This parameter defaults
to the appropriate netmask, based on the class of
IP address. You must specify NetMask only if IP
subnets are used.
[MTU] Maximum transfer unit assigned for this client.
Value/Field Size
0-125
Local, External, None
13-20 byte hex-based/
Up to 59 characters
Dot decimal/
7-15 characters
Dot decimal/
7-15 characters
64 to 10160
SmartSwitch ATM Switch Reference Manual 2-83
IPATMClient
Default
0
None
No default
No default
255.0.0.0,
255.255.0.0 or
255.255.255.0
9180