Spvp - Cabletron Systems SmartSwitch 2500 Reference Manual

Spvp

(SmartSwitch 6500 Only)
Use SPVP to add, delete, or show soft PVPs (SPVPs) on the switch. An SPVP connects this switch (the source switch)
to a switch across the ATM network (the target switch).
Note Before adding an SPVP at this switch, you must configure the target address at the
target switch.
Operators
add, delete, show
Parameters
Input Parameter
[PortNumber]
[SourceVpi]
[DestinationSelectType]
[DestinationVpi]
[TargetAddress]
[ForwardTrafficDescriptor
Index]
[BackwardTrafficDescriptor
Index]
[RetryInterval]
Description
Port number on the switch. (Physical port used
as SPVP source port.)
VPI allocated to the SPVP source port.
Specifies whether or not the destination VPI
input at the source switch must be used as the
target port (at the target switch). If you specify
Required, the VPI specified in the
[DestinationVpi] input parameter must be used
as the target port. If you specify Any, the target
switch can use any VPI as the target port.
VPI allocated to the target port.
Destination (target) address to which the SPVP
should attempt to connect.
Index of the forward (source to target) traffic
descriptor.
Index of the backward (target to source) traffic
descriptor.
Time interval between SPVP retries.
Value/Field Size
A1 to B4 (2500 family),
1A1 to 8B4 (6500),
or All
Required, Any
20-byte address
0-3600000 milliseconds
SmartSwitch ATM Switch Reference Manual 2-301
Spvp
Default
All
Required