Ilmiconfig - Cabletron Systems SmartSwitch 2500 Reference Manual

IlmiConfig

IlmiConfig
Use IlmiConfig to manage ILMI timers specified in ILMI 4.0 and to enable or disable ILMI functions.
The following applies to SmartSwitch 6500 only: You can hot-swap TSMs.
Note
Hot-swapping is replacing a module when the chassis is powered up. If you
replace a TSM with another TSM of the same type (same I/O ports), existing
configuration of port parameters is not affected. This includes parameters set
using any of the following attributes: ATMRoute, CACServiceClassBw,
IlmiConfig, NetPrefix, Port, PortConfig, PVC, PVP, ServiceRegistry, SigTimer,
SigStatistics, SSCOPConfig, and SSCOPStatistics. If you replace a TSM with
another TSM of a different type, existing configuration of port parameters is
deleted. The deletion occurs when the new module is plugged into the chassis
backplane.
Operators
modify, show
Parameters
Input Parameter
[PortNumber]
[IlmiAddressRegistration]
[IlmiConnectivity]
[Timer-S]
[Timer-T]
[Factor-K]
2-78 SmartSwitch ATM Switch Reference Manual
Description
Port number on the switch. You can
specify a physical or virtual port.
Controls ILMI address registration.
Controls ILMI connectivity.
Timer S in seconds for establishing
ILMI connectivity.
Timer T in seconds for checking
ILMI connectivity.
Number of K consecutive polls for
which no ILMI response is received
before ILMI connectivity is declared
lost.
Value/Field Size
A1 to B4 (physical-2500 family),
A1.n to B4.n (virtual-2500 family),
1A1 to 8B4 (physical-6500),
1A1.n to 8B4.n (virtual-6500),
or All
Enable, Disable
Enable, Disable
1-65535
0-65535
0-65535
Console Commands
Default
All
Enable
Enable
1
5
4