Cabletron Systems SmartSwitch 2500 Reference Manual page 280

PVP
In the Output Parameter table below, (</d>) indicates parameters that are available only through the
(detailed) command.
Output Parameter
[Conn Id]
[Conn SubId]
[Low Port]
[Low VPI]
[Low Type]
[High Port]
[High VPI]
[High Type]
[Admin Status]
[Low - High Traffic Decs Index (TX)] </d>
[High - Low Traffic Decs Index (RX)] </d>
[Low to High Operation Status] </d>
[High to Low Operation Status] </d>
[Port Status] </d>
[Creation Time] </d>
[Traffic Type (High-Low)] </d>
[Early Packet Discard (High-Low)] </d>
2-252 SmartSwitch ATM Switch Reference Manual
Description
Cross-connect ID of the PVP (as assigned by switch software).
Each PTP PVP has a unique cross-connect ID. PMP PVPs might
have the same cross-connect ID but different cross-connect sub
IDs.
Cross-connect sub-ID of the PVP. Each PTP PVP and PMP PVP
has a unique cross-connect sub-ID.
Number of the Low Port (based on lexical order).
VPI of the Low Port.
Connection type from perspective of Low Port.
Number of the High Port (based on lexical order).
VPI of the High Port.
Connection type from perspective of High Port.
Administrative status of the PVC. Possible values are: Up or
Down.
Index of the traffic descriptor in the direction of flow from Low
Port to High Port.
Index of of the traffic descriptor in the direction of flow from
High Port to Low Port.
Operational status of low-to-high connection. Possible values
are: Up or Down.
Operational status of high-to-low connection. Possible values
are: Up or Down.
Operational status of port.
Time the PVP was created (relative to the switch boot time).
Traffic type in the high-to-low direction.
Early packet discard as calculated by CAC for the cross connect
in the high-to-low direction.
show pvp /d