Cassette Compartment Removal/Installation - Sony GY-2120WD Maintenance Manual

1-1. Removal/Installation of Cabinet
1-1-2. Cassette Compartment Removal/
Installation
Removal
n
Take out the tape before removing the cassette compart-
ment when the tape exists in the cassette compartment.
1. Turn the power OFF.
2. Remove the upper lid. (Refer to Section 1-1-1.)
3. Remove the plate MD assembly. (Refer to Section 1-1-1.)
4. Loosen the two screws and remove the cassette
compartment bracket assembly.
5. Disconnect the connector (CN930) on CL-29 board.
Screw
(B3 x 6)
(with stopper)
Removal of the Bracket Assembly
6. Hold the portions marked A (two) of the cassette
compartment as shown in the figure and lift straight up
slightly. Then come off the four legs for fixing
positions of the cassette compartment.
7. Hold the portion marked B (one) of the cassette
compartment as shown in the figure and slide the back
and forward by suspending it in the direction of the
arrow.
Then remove the cassette compartment from the unit.
c
Do not move the cassette compartment to right and
left. If unnecessary force is applied, a gear position
might be changed or some parts might be removed.
Cassette compartment
Left side panel
Removal of the Cassette Compartment
1-2
Bracket assembly
Screw (B3 x 6)
(with stopper)
CL-29 board
Connector
(CN930)
A
B
A
Right side panel
8. When putting the removed cassette compartment
outside of the unit, make the four legs for fixing
position faced down.
(Because the flexible card wire might be get damaged
if the cassette lid is faced down.)
Installation
9. Put the harness of the connector (CN930) disconnected
in step 5 to the place that is not caught between chassis
and cassette compartment.
10. Install the cassette compartment while inserting
slantingly in the direction as shown in the figure.
11. While pressing a portions marked C (two) of the
cassette compartment as shown in the figure, insert
the four legs for fixing the positions of the cassette
compartment into the four holes for fixing the
positions of the mechanical chassis.
12. Connect the connector (CN930) on the CL-29 board.
13. After confirming that the cassette compartment is
fixed to the chassis surely , install the bracket
assembly.
Cassette lid
C
Leg for fixing
the position
Hole for
fixing the position
Flexible card wire
Installation of the Cassette Compartment
Cassette compartment
C
Connector
(CN930)
Mechanical chassis
GY-2120WD/WS