Table of Contents
Advertisement
6-3. Error Processing
6-3-5. System Error Code
If multiple system errors occur, the priority level of the error code display is as follows:
2x94,2x93,2x91,2x97,
2x02,2x03,2x04,2x05,2x07,2x06,2x01,2x09,2x08,2x0a,
2x10,2x11,2x12,2x13,
2x20,2x21,2x22
n
In the "Protection mode" described in this section, the servo control system automatically stops the tape transport and drum
motor, and maintains the state. The current mode cannot be automatically returned when it enters the protection mode.
When the protection mode is entered with the cassette tape inserted, take out the cassette tape manually with reference to
Section 1-5. Do not turn the power on again without taking out the cassette tape. This may damage the tape.
2x 01
(ERROR 01) Tape slacked in THREAD mode
Description:Tape slacking was detected during threading or unthreading.
Detection conditions:
Subcode:
Possible cause:
Protection operation:
c
Be sure to take out the cassette manually (refer to Section 1-5). Do not turn the power on again without
taking out the cassette. This may damage the tape.
6-160
1) When no take-up reel FG can be detected in the unthread operation just after activation
2) When the relation between the take-up reel FG and threading FG is out of the specifica-
tion in operations other than unthread just after activation
None (Displays 00.)
. Cassette compartment trouble or installation defect
*
The reel did not rotate because the cassette was lifted-up from the specified position.
. Clearance adjustment defect of take-up reel FG detection block
. Take-up reel FG amplifier (DR-327 board or MS-54 board) trouble
. Take-up reel motor trouble
. Take-up reel motor drive circuit (DR-327 board or MS-54 board) trouble
. Take-up reel brake trouble
. Take-up reel brake solenoid drive circuit (MS-54 board) trouble
. Servo adjustment defect on take-up reel
. Harness disconnection
. Take-up reel table height adjustment defect
Enters the protection mode.
GY-2120WD/WS
Advertisement
Table of Contents
Troubleshooting
