Table of Contents
Advertisement
5. Place the Reel Shift Plate Assembly in
the S Cassette Position
Rotate the drive gear clockwise as far as it will
go.
6. Check the Supply and Take-up Reel
Table Height
Perform in the same way as in steps 3 and 4.
If the specification is not satisfied, perform steps
7 and later.
If the specifications are satisfied in both the L and
S cassette positions, perform steps 9 and later.
GY-2120WD/WS
<S cassette position>
S reel table
Drive gear
Reel table
Flange
*
**
Spec.: The*marked portion of the gauge slide over
the flange of the reel table.
The**marked portion of the gauge does not
slide over.
Reel Table Height Check (S)
4-4. Reel Table Height Adjustment
T reel table
Reel table height
check gauge
Cassette reference plate (L)
4-7
Advertisement
Table of Contents
Troubleshooting
