Sony GY-2120WD Maintenance Manual page 253

Error Codes from SYS CPU
Codes Contents
0000011B Failed in downloading to the SYS CPU or SV CPU
00000123 Could not READ/WRITE from/to the tape properly even after the specified retry process
00000124 The servo did not lock at the start of READ/WRITE
00000125 The servo fails during READ/WRITE
00000126 Tape positioning error
00000128 Failed in resetting the ID for starting READ/WRITE.
00000129 Detected change in ID during READ/WRITE.
00000147 Firming error occurred in the data sent to DPR from the memory.
00000148 Firming error occurred at the DPR of the data sent to the memory the from the DPR.
00000149 Firming error occurred at the memory of the data sent to the memory the from the DPR.
0000013A Time out although the DATA READY signal for transmission start was waited
0000013B Could not read the ID at the start of READ/WRITE
0000013C There were some areas not recorded with the ID during READ
0000013D There were some areas not recorded with CTL
00000141 Parity error occurred at the memory while the data sent to DPR from the memory
00000142 Parity error occurred at the DPR while the data sent to DPR from the memory
00000143 Parity error occurred at the DPR while the data sent to the memory from the DPR
00000144 Parity error occurred at the memory while the data sent to the memory from the DPR
00000145 1-bit error occurred in the memory, and it is corrected
00000146 More than 2-bit error occurred in the memory
0000015C Cassette is write-prohibited
0000017A Attempted to READ/WRITE during tape end
0000017B Tape end occurred during READ/WRITE
0000017C Received REW at the tape top
0000017E Different from the completed state when tape operations complete
0000017F Time-out after waiting for the instructed tape operations to start/end
000001BB Could not eject the cassette when executing the servo adjustment/check command.
000001Cy Error occurred at initial check (y: initial check error code)
GY-2120WD/WS
6-2. Command Description
6-29