Table of Contents
Advertisement
Removal
1. Put the Unit into the Unthreading End
Mode
Refer to step 2 in Secrtion 3-1-3.
2. Remove the S Tension Regulator
Assembly
(1) Disconnect the connector CN18 on the MS-
54 board.
(2) Remove the two screws (PS3 x 8), and
remove the L cassette support plate (S)
assembly.
(3) Remove the screw and two L cassette support
spacer (S), and remove the S tension regula-
tor assembly.
n
Never disconnect connector CN1 on the TR-
78 board.
If so, the adjustment the S tension regulator
assembly get out of order and can not be
repaired
GY-2120WD/WS
http://getMANUAL.com
MS-54 board
Screw
(PS3 x 8)
Connector
(CN1)
TR-78 board
Screw
(PWH3 x 8)
Remove the S Tension Regulator Assembly
3-4. Drum Entrance Side Block
Connector (CN18)
Screw (PS3 x 8)
S tension regulator assembly
3-45
Advertisement
Table of Contents
Troubleshooting
