Table of Contents
Advertisement
Continuedfrom previous page
Error code
Description
1x46
More than 2-bit error occurred in the memory.
1x5C
Cassette in GY-2120 is a write-protected state.
1x7A
Read or write at the tape end.
1x7B
Reach to the tape end during reading or writing.
1x7C
Receive REW at the tape top.
1x7E
Different from the completed state when tape operations ended.
1x7F
Waiting for start/end of instructed tape operations and timed out.
1xBB
Cannot eject the cassette during execution of servo adjustment/check
command.
1xCy
Error occured in initial check (y; initial check error code).
2x01
The slack of the tape is detected during threading or unthreading.
2x02
The slack of the tape is detected in search, cue-up, fast forward or rewind
mode.
2x03
The slack or breaking of the tape is detected in recording or playback mode,
or either of the lock of the supply or take-up reel is detected.
2x04
Tape does not run at the speed of designation in fast forward or rewind mode.
2x05
FG count of the supply or take-up reel is out of specification at the
diagnostics before loading (in pulling down the cassette compartment).
2x06
Excessive tension is detected in recording or playback mode.
2x07
It is detected that the capstan does not rotate at the speed of designation in
play or search mode. Otherwise, FG count of capstan is out of specification.
2x08
The number of revolutions of drum motor is out of specification.
2x09
It is detected that threading or unthreading is not completed.
2x0A
It is detected that the tape top process at the thread is not completed,
therefore threading can not be done.
2x10
Condensation is detected.
2x11
The tape top or and sensor operation is defective.
2x12
The tape top sensor operation is defective.
2x13
The tape end sensor operation is defective.
2x14
Detected overheat. Problems were also detected in the cooling fan motor.
2x20
It is detected that cassette up/down operation is not completed.
2x21
It is detected that driving of the L position to S position or the S position to
L position in the reel table is not completed.
2x22
The operation of the L/S position sensor of the reel table is defective.
2x91
Servo reference signal (VD) is defective.
2x93
The interface between SV (IC806 on the MA-83 board) and EQ (IC600 on
the EQ-66 board) is defective.
2x97
The operational defect of the NV-RAM on the MS-54 board.
"x" mark in the error code indicates an arbitrary number.
Any number can be assigned to "x"
When this error code is indicated on the LCD.
For details of the meaning of "x" at the second place from the left of the error code, refer to "Commands to SYS Side CPU" on page 6-27.
GY-2120WD/WS
6-3. Error Processing
Remedies (probable causes)
(Write-protect tab was pressed down)
Check GY-2120.
Replace MA-83 board.
Refer to Section 6-3-3.
6-159
Advertisement
Table of Contents
Troubleshooting
