Table of Contents
Advertisement
3-6. Drum Exit Side Block
(7) Confirm that the height of the T drawer arm
satisfies the specification 3 with the T drawer
arm turned to clockwise by finger.
If specification 3 is not satisfied, perform the
procedures (4) and later again.
n
Some of the T drawer assemblies have no
arm stopper. In these cases, the confirmation
described above, step 7, is not required.
Adjustment after Replacement
5. Adjust the Slant Guide Slantness
Refer to Section 4-9.
3-82
< Side view >
B
T drawer arm
B
Spec.3 :
0.2 mm
(Between arm stopper and arm)
T Drawer Arm Height Adjustment
Arm stopper
T drawer assembly
GY-2120WD/WS
Advertisement
Table of Contents
Troubleshooting
