Table of Contents
Advertisement
SV0A
Free Speed Adjust (Servo adjustment command)
SV0B
RF Switching Position Adjust (Servo adjustment command)
Function: SV0A: Adjusts the free speed of a capstan motor.
Operation: The commands above are the same in operation.
Examples:
. For SV0A (When the adjustment succeeds)
------>sv0a
Servo Adjust [Auto Adjust]
Free Speed Adjust
Set YR2-1 (Alignment Tape)
Are you ready (y/n/else=Eject)? Yes
Adjust Complete
------>_
. For SV0B (When the adjustment succeeds)
------>sv0b
Servo Adjust [Auto Adjust]
RF Switching Position Adjust
Set YR2-1 (Alignment Tape)
Are you ready (y/n/else=Eject)? Yes
Adjust Complete
------>_
GY-2120WD/WS
SV0B: Adjusts the RF switching position.
(1) Enter command.
After the title, the following message is then displayed on the screen.
Set YR2-1 (Alignment Tape)
Are you ready (y/n/else=Eject)?
* To stop the execution of adjustment, press the N key.
* To eject of cassette tape, press a key except Y and N.
(2) Insert alignment tape YR2-1 into this unit.
* Do not use tapes other than YR2-1. It is impossible to perform this adjustment properly in this case.
* To move the tape address during adjustment start, use the control software of GY-2120. (Refer to Section 1-10.)
(3) Press the Y key to initiate adjustment.
During adjustment, message "Adjusting....." is displayed on the screen.
* Press the Y key without inserting a tape to display the message again.
* Message "# Adjust Incomplete (Tape end detected) #" is displayed on the screen, rewind the tape to tape top,
then readjust.
(4) Message "Adjust Complete" is displayed on the screen when the adjustment succeeds.
Message "# Adjust Incomplete #" is displayed on the screen when the adjustment fails.
For the failure of adjustment, refer to page 6-53.
(5) To save adjustment data in the NV-RAM (Non-volatile RAM), execute command
SV0C (Servo NV-RAM Save).
* After other servo adjustment, servo adjustment data can be collectively saved in the NV-RAM.
. For SV0A (When the adjustment fails)
------>sv0a
Servo Adjust [Auto Adjust]
Free Speed Adjust
Set YR2-1 (Alignment Tape)
Are you ready (y/n/else=Eject)? Yes
# Adjust Incomplete #
------>_
. For SV0B (When the adjustment fails)
------>sv0b
Servo Adjust [Auto Adjust]
RF Switching Position Adjust
Set YR2-1 (Alignment Tape)
Are you ready (y/n/else=Eject)? Yes
# Adjust Incomplete #
------>_
6-2. Description of Commands
6-97
Advertisement
Table of Contents
Troubleshooting
