Table of Contents
Advertisement
6-2. Command Description
b) SV/RF Maintenance Mode (Drive maintenance mode command No. 2)
This mode is used to adjust the servo and RF systems of the GY-2120.
To activate the SV/RF maintenance mode, enter command number "2" with "MDRV=>" displayed
as the prompt of a PC. "- - - - - ->" is then displayed as the prompt.
Enter a command number (or command) after this prompt and press the ENTER key. The command
function is then executed. To terminate the SV/RF maintenance mode, enter "QUIT" after this
prompt and press the ENTER key.
n
The SV/RF maintenance mode cannot be activated from another mode. To activate the SV/RF
maintenance mode, terminate the current mode and enter "MDRV", then "2".
The commands used in the SV/RF maintenance mode are described on the 6-79 page.
c) SYS/SV All Log Upload (Drive maintenance mode command No. 80)
Enter "80" after MDRV, and press the ENTER key.
Function for uploading all SYS and SV logs to the PC.
d) MDRV All Log upload (Drive maintenance mode command number 81)
Enter "81" after MDRV, and press the ENTER key.
Function for uploading all SYS and SV logs, HOURS METER, and Abort Reason Code to the PC.
e) SV Log upload (Drive maintenance mode command number 85)
Enter "85" after MDRV, and press the ENTER key.
Function for uploading all SV logs to the PC.
f) Base Mode Log Upload (Drive maintenance mode command number 86)
Enter "86" after MDRV, and press the ENTER key.
Function for uploading all SYS logs to the PC.
g) Status Log Upload (Drive maintenance mode command number 87)
Enter "87" after MDRV, and press the ENTER key.
Function for uploading all SYS log to the PC.
h) Time Code Log Upload (Drive maintenance mode command number 88)
Enter "88" after MDRV, and press the ENTER key.
Function for uploading all logs indicating details of recording/playback by the SYS to the PC.
6-58
GY-2120WD/WS
Advertisement
Table of Contents
Troubleshooting
