Table of Contents
Advertisement
Adjustment
7. Adjust the CTL/TC Head Azimuth
(1) Turn the azimuth adjustment screw clockwise
so that the specification is satisfied.
(2) Strike the portions A and B shown in the
figure lightly with the tip of a screwdriver.
Then check that the specification is satisfied.
In case the adjustment is performed
8. Adjust the CTL/TC Head Position
Refer to Section 5-7.
9. Check the CTL/TC Head Height
Refer to Section 5-5.
10. Check the CTL/TC Head Azimuth
Refer to steps 6 and 7 in this section.
GY-2120WD/WS
Height adjustment screw
Azimuth adjustment screw
CTL PLS
(TP710/EQ-66)
A
RSYC
(TP705/EQ-66)
Spec. : A = 5 ±50 us
CTL/TC Head Azimuth Adjustment
5-6. CTL/TC Head Azimuth Adjustment
Portion B
Portion A
5-27
Advertisement
Table of Contents
Troubleshooting
