Sony GY-2120WD Maintenance Manual page 69

8. As "Write OK? (y/n):" will be displayed at the PC, if the Menu No. and file
name input are correct, enter "y". To enter a new Menu No. and file name, enter
"n".
Example:
If the current input are correct
Write OK?(y/n) : y "
To enter again
Write OK?(y/n) : n "
When "y" is entered, download will start immediately. When "n" is entered, the
prompt will be displayed again. Repeat from step 5.
9. The following are displayed on the PC, and download starts.
Open File Length : XXXXXX byte
Start>>
10. Check that the following are displayed on the GY-2120 front panel.
Firmware Display
SCSI DownLoad SC CPU
SYSCON DownLoad SYS CPU
SERVO DownLoad SV CPU
IF DownLoad IF CPU
n
Even if the following are displayed on the PC, writing to the ROM will not have
completed.
Start >> ** >> Finish. (Send Data Cnt : XXXXXX byte)
If the power of GY-2120 is turned off during writing, the ROM data may be
damaged in some cases, which will require the ROM to be replaced.
11. Wait until "No Tape" is displayed on the front panel of GY-2120.
GY-2120WD/WS
* XXXXXX is the file size of the file
being download
Required time to end
(When Baud Rate:38400 bps)
Approx. 6 minutes
Approx. 7 minutes
Approx. 3 minutes
Approx. 2 minutes
1-13. Download by Special Tool
1-59