Table of Contents
Advertisement
%\ : H_DPR_REG1_8 (C1 burst error (Dch)) (Hex)
Number of blocks which could be C1 corrected normally.
When the burst error has not occurred for all, then;
D0 (Hex) = 208 block
Normal value
%; : H_DPR_REG1_F (read exor data)
%' : H_DPR_REG1_E (Processor test mode)
%, : H_DPR_REG1_D (IC test report (c2 enc/dec))
%. : H_DPR_REG1_C (IC test control (diag mode))
1 to 4 : V_LTCR (BCD, Time Code)
Absolute Time Code value when the LTC is soft-corrected by READ_TIME
aa : hours
bb : minutes
cc : seconds
dd : Frames
5 : l_search_count (Hex, Frame)
Number of frames counted by IDC (C_CTL_COUNT) while executing longitudinal search
CMD.
As each block is reset by block with 50 frames as one block, the frames change from Frame 1 to
51 (=33 Hex).
!= to !\ : C_CTL_COUNT (BCD, Time Code)
Relative Time Code value at which the counted by Reel FG
(Reference when the CTL signal is not recorded)
aa : hours
bb : minutes
cc : seconds
dd : Frames
GY-2120WD/WS
D0
6-2. Description of Commands
6-77
Advertisement
Table of Contents
Troubleshooting
