Table of Contents
Advertisement
Adjustment
4. Adjust the TG-1 and TG-2 (Entrance
Guide) Height
(1) Put the unit into the FWD mode.
(2) Turn the height adjustment nut of TG-1 and
the upper flange of TG-2 using a tape guide
adjustment driver and adjust the height of
TG-1 and TG-2 so that the specification 1 is
satisfied.
5. Recheck the Tape Running at Drum
Entrance Side
Refer to step 3.
If the specification 1 is not satisfied, perform the
adjustment in step 4 again.
Height adjustment nut
GY-2120WD/WS
TG-1
TG-0
Tape Running Adjustment at Drum Entrance Side
5-3. Tape Running Adjustment
TG-2
5-7
Advertisement
Table of Contents
Troubleshooting
