Sony GY-2120WD Maintenance Manual page 257

4 Log messages
Log Message
Controller Power Error!!
Copy!!
Copy Fail!! - Error Code = xxxxxxxx
Delete Partition complete!!
Del Partition - Error Code = xxxxxxxx
Drive Power Error!!
Drive System Error!!
Error!! - Bad Tape (sb=xxxxxxxx/l= xxx)
Error!! - Block Table Broken
Error!! - Edac Multiple Error
Error!! - FIT Overflow (cmd=xx)
Error!! - Framing Error
Error!! - Identify (sb=xxxxxxxx/l=xxx/r
=xxxxxxxx)
Error!! - Parity Error
Error!! - Tape Full (cmd=xx)
Fast Load Complete!!
Fast Load Fail!! - Error Code=xxxxxxxx
Fast Load Fail!! - Insert Virgin Tape
Fast Load Fail!! - SCSI Bus Reset
Fast Load Fail!! - Update Table is ON
Fast Unld complete!!
Fast Unld Fail!! - Error Code=xxxxxxxxx
Format Complete!!
Format Fail!! - SCSI Bus Reset
Format Fail!! - Error Code = xxxxxxxx
Load Complete!!
Load Fail!! - Insert Virgin Tape
Load Fail!! - SCSI Bus Reset
Load Fail!! - Update Table is ON
Load Fail!! - Error Code = xxxxxxxx
Load Switch ON !!
Maintenance Monitor Used
Make DIT Fail!! - Error Code = xxxxxxxx
Make New DIT Complete!!
GY-2120WD/WS
Contents
Detected power supply defect while GY-2120 was operating.
Executed the copy command.
The copy command failed due to error.
Completed erasing the partition.
Failed in erasing the partition due to error.
Detected power supply defect of GY-2120.
System error occurred at GY-2120.
Tape not managed by DTF
sb → Data written in sub code
1 → Internal ID number in the bank
Block management table was abnormal.
Error was found in the buffer memory.
The FIT (File Information Table) has overflowed.
cmd → SCSI command when error occurred
Error was found while writing from the buffer memory to the tape.
Error was found in the subcode area.
Sb → Data written in the sub code
1 → Internal ID number in the bank
r → (Unnecessary)
A parity error was found in the data in the buffer memory.
Table has become full.
cmd → SCSI command when the error occurred
DIT data reading and first loading have completed.
Failed in first loading due to error.
Error Code → Displays the SCSI error code in 4 bytes
Uninitialized tape was inserted.
SCSI bus reset occurred during mounting.
Tape which was not normally unmounted previously
First loading completed normally.
Failed in first loading due to error.
Error Code → Displays the SCSI error code in 4 bytes
Completed tape initialization.
SCSI bus reset occurred during tape initialization.
Failed in tape initialization due to error.
Error Code → Displays the SCSI error code in 4 bytes
DIT data reading and mounting have completed.
New tape was inserted.
The SCSI BUS was reset during loading.
Tape which was not unloaded normally previously.
Failed in loading due to error.
Error Code → Displays the SCSI error code in 4 bytes
The GY2120 UNLOAD button was pressed.
The maintenance mode was used.
Could not create new volume due to error.
Error Code → Displays the SCSI error code in 4 bytes
Created new DIT.
6-2. Command Description
6-33