Table of Contents
Advertisement
6-3. Error Processing
2x 03
(ERROR 03) Tape slacked in REC/PLAY mode
Description:Tape slacking, tape exhausted, or supply or take-up reel lock was detected in the REC or
Detection conditions:
Subcode:
Possible cause:
Protection operation:
c
Be sure to take out the cassette manually (refer to Section 1-5). Do not turn on the power again without
taking out the cassette. This may damage the tape.
6-162
PLAY mode.
1) When the take-up value is lower than the specified value with respect to the tape supply
value
2) When the relation between the capstan FG, supply reel FG, and take-up reel FG are out
of the specification
3) When the supply reel and take-up reel do not coincide in rotation direction continuously
for more than five seconds
4) When the tension value calculated from the supply tension sensor output is less than
15 g continuously for more than three seconds
None (Displays 00.)
. Cassette compartment trouble or installation defect
*
The reel did not rotate because the cassette was lifted-up from the specified position.
. Clearance adjustment defect of supply or take-up reel FG detection block
. Supply or take-up reel FG amplifier (DR-327 board or MS-54 board) trouble
. Supply or take-up reel motor trouble
. Supply or take-up reel motor drive circuit (DR-327 board or MS-54 board) trouble
. Capstan motor trouble
. Capstan motor drive circuit (DR-327 board or MS-54 board) trouble
. Capstan FG amplifier (DR-327 board or MS-54 board) trouble
. Servo adjustment defect on capstan, reel, and supply tension sensor
. Supply or take-up reel brake trouble
. Supply or take-up reel brake solenoid drive circuit (MS-54 board) trouble
. Harness disconnection
. Reel table height adjustment defect
. Tape path and drum troubles
. Tape abnormality (The winding state has a problem.)
Enters the protection mode.
GY-2120WD/WS
Advertisement
Table of Contents
Troubleshooting
