Table of Contents
Advertisement
3-2. Reel Block
4. Remove the Reel Shift Plate Assembly
While pulling out the slide shaft and remove the
reel shift plate assembly.
c
1. Be careful not to adhere grease smeared the
slide shaft to another parts.
2. Be careful not to cause damage to the slide
shaft during removal.
5. Disconnect the Flat Cable
Disconnect the flat cable connected with RM-82
board.
6. Disconnect the Connectors
Disconnect the two connectors CN926 and
CN927 on the RM-82 board.
3-16
Reel shift plate assembly
Remove the Reel Shift Plate Assembly
Connector (CN927)
RM-82 board
Flat cable
Disconnect the Flat Cable and Connectors
Slide shaft
Connector (CN926)
GY-2120WD/WS
Advertisement
Table of Contents
Troubleshooting
