4-3.
Lens Block
Note:
A protective Lens Cap is attached to each new service
Lens Block.
Carry out replacement work with this Lens Cap attached.
4-3-1.
Removal of Front Ornament
1.
Disconnect the three connectors and peel off the Adhesive Parts of the Motor A Flexible Board, Motor B Flexible
Board, and the FP-2126 Flexible Board.
P
T O
Connector
Adhesive part
FP-2126 Flexible
Board
2.
Remove the seven screws and remove the Sheet Metal (C) and the Mecha Stop Rubber while detaching the two
bosses, and then peel off the Adhesive Part of the FP-2125 Flexible Board.
P
T O
Mecha Stop Rubber
HDR-CX620/HDR-CX670/HDR-PJ620/HDR-PJ670
Lens Cap
Flexible Board of the Motor B
Adhesive part
Adhesive part
FP-2125 Flexible
Board
Flexible Board of
the Motor A
Connectors
Screws
Sheet Metal (C)
Screws
Boss
Screw
Screw
FP-2125
Flexible Board
Screw
Boss
Adhesive part
4-25