Front Panel Reference
I/O Key Group
DIO Configuration Dialog Box
This dialog box provides the following parameters for setting the configuration of
the Digital I/O interface.
Pin #
Function
Polarity
Output Trigger
Type
Output Trigger
Timing
Output Pulse
Width
For more information about the trigger function, see
page
DIO Read/Write Dialog Box
This dialog box provides the following parameters for reading or writing a value set
to the Digital I/O interface.
Format
Mask Value
Value
194
Digital I/O pin number, 1 to 7
This field specifies the pin set by this dialog box.
Function of the specified pin of the Digital I/O interface,
DIGITAL I/O (digital signal input/output), DIGITAL IN (digital
signal input), TRIGGER OUT (trigger output), or TRIGGER IN
(trigger input)
Polarity of the input/output function, POSITIVE (POS., positive)
or NEGATIVE (NEG., negative)
Type of output trigger, EDGE (edge) or LEVEL (level)
Timing of the output trigger, AFTER (after action (arm, trigger,
and device action)), BEFORE (before action), or BOTH (both)
Pulse width of the output trigger, 10 s to 10 ms
182.
Format of the value set to the Mask Value field and the Value
field, BIN (binary), DEC (decimal), or HEX (hexadecimal)
Mask value which indicates the pattern of the un-used bits of
the Digital I/O interface
The READ assist key is used to read the mask value presently
set to the Digital I/O interface.
The WRITE assist key is used to set the specified mask value to
the Digital I/O interface.
Value set to the Digital I/O interface
"Trigger Key Group" on
Keysight B2980B User's Guide, Edition 1