Omron DRT2 Series Operation Manual page 89

Remote I/O Terminals with Transistors
Setting Node Addresses
Using the DeviceNet
Configurator
1,2,3...
Baud Rate Setting
Output Hold/Clear
Setting
Setting Output Hold/Clear
from the Configurator
1,2,3...
72
1. Click the right mouse button over the icon of the corresponding DRT2-se-
ries Smart Slave in the Network Configuration Window, and select Change
Node Address.
2. The following window will be displayed. Enter the desired node address.
3. Click the OK Button.
Note Any node address within the setting range can be used as long as it is not
already set for another node. Setting the same node address for more than
one node will cause a node address duplication error and communications will
not start.
The baud rate of the whole system is determined by the baud rate set for the
Master Unit. Setting the baud rate for each Unit is not required.
Use the Configurator to set the output hold/clear settings. The factory setting
is for outputs to be cleared. The setting method is shown below.
1. From the Main Window, open the Network Configuration Window and dou-
ble-click or click the right mouse button over the icon of the corresponding
DRT2-series Smart Slave. Select Parameter and Edit to display the Edit
Device Parameters Window.
From the Maintenance Mode Window, open the Network Configuration
Window in the Configurator and click the right mouse button over the icon
Section 5-3